drip edge

What Is Drip Edge, and Why Does a Roof Need It?

Drip edge is a strip of metal installed along the eaves and rakes of a roof. It carries water off the shingles and drops it into the gutter or clear of the wall, instead of letting it curl back onto the fascia and roof deck. In Nebraska, it is standard on any new shingle roof.

Where does drip edge go, and what does it look like?

Drip edge runs along every edge of the roof: the eaves and the rakes. From the ground it looks like a thin metal lip just under the first row of shingles.

The eaves are the lower, level edges where the gutters hang. The rakes are the sloped edges on the gable ends, running from the eave up to the peak. The fascia is the board that runs along the eave behind the gutter, and the roof deck is the plywood or OSB sheathing the shingles are nailed to.

In cross section, drip edge is bent so one flange lies flat on the deck and the other turns down over the edge of the deck and the top of the fascia. The lower edge is usually kicked out slightly so water falls away from the wood instead of clinging to it. Without that bend, water running off the shingles tends to wrap around the edge (it follows the surface by surface tension) and soak the top of the fascia and the edge of the deck.

How does drip edge fit with the underlayment and ice and water shield?

At the eaves, drip edge goes on first and the underlayment laps over it. At the rakes, the underlayment goes on first and drip edge goes over it.

Underlayment is the layer of felt or synthetic sheet between the deck and the shingles. Ice and water shield is a self-sticking rubberized membrane laid along the eaves and in valleys, where ice and melting snow back up. The order matters because water has to move downhill from one layer onto the next, never behind one:

  • At the eave, ice and water shield lies over the drip edge flange, so any water that gets under the shingles runs across the membrane and out over the metal.
  • At the rake, drip edge sits on top of the underlayment, so wind-driven rain hitting the side of the roof is shed over the edge instead of getting under the paper.
  • Shingles at both edges hang slightly past the drip edge so water drips clear.

If the eave is lapped backward, water that reaches the membrane can run behind the metal and into the deck. That backup is the same trouble covered in our post on preventing ice dams on Nebraska roofs, and a correctly lapped eave is part of the defense.

Does the building code require drip edge?

Yes, for asphalt shingle roofs under current residential code. The International Residential Code, which most Nebraska communities adopt in some version, calls for drip edge at eaves and rakes on new shingle roofs.

Your city or county sets which code edition applies and how it is enforced, so the building department is the place to confirm local details. On a full replacement, drip edge should appear as its own line in the written scope. When you compare bids, our guide on how to judge a roof quote explains what a complete scope looks like, and drip edge belongs on that list.

What happens to the wood when drip edge is left off?

The edge of the deck and the top of the fascia stay wet after every rain and rot from the outside in. The damage is easy to spot once you know where to look.

Signs along an edge without drip edge:

Paint peeling or blistering along the top inch or two of the fascia. Dark staining or soft spots on the fascia board, especially behind gutters. Shingle edges that sag or droop because the deck under them has softened. Wasps or birds getting in through gaps where the deck edge has crumbled. Water streaks on the siding below the rakes.

Press a screwdriver gently into the fascia where it looks stained. If it sinks in easily, the wood has rot, and the deck edge above it likely does too.

Can drip edge be added without replacing the roof?

Often, yes. A crew can lift the first course of shingles, slide drip edge in, and reseal, though how well that works depends on the shingles' age and condition.

Old, brittle shingles may crack when lifted, and rotted fascia or deck edges should be replaced before new metal goes on. If the roof is close to the end of its life, it usually makes more sense to install drip edge as part of a new residential roof, lapped correctly from the start.

If you are not sure whether your roof has drip edge, or the fascia is showing any of these signs, Rocket Roofing General Contractor can take a look. Request a quote here for work in the Omaha metro, Lincoln or anywhere in Nebraska.

Question Answered? The Assessment Is Free.

1,000+ projects completed. Serving Nebraska since 2008.

Book a Free Assessment

Or call (402) 291-8888